Powder shield with EnviroScreen ™ protection SPF 50


Powered by EnviroScreen® technology, this all-powerful, all-mineral skin shield delivers all-around protection in one convenient, on-the-go application, alone or over makeup.

Now with a new and improved brush system for easier preparation and activation. 

Net Weight: 0,21oz. / 6g
90-day supply based on typical use

UVA protection rating: The PA rating measures protection against UVA rays only, and ranges from PA+ to PA++++. UVA rays are so-called “aging” rays.

UVB protection rating: The SPF rating measures protection against UVB rays only. UVB rays are so-called "sunburn" rays.

Provides environmental protection against UVA/UVB, pollution, blue light, and infrared radiation.
+ Flecks of encapsulated pigments adjust to skin's natural tone
+ Hydrating and antioxidant-rich formula
+ Free of parabens, sulfates, phthalates, oil, dyes, and fragrance
+ 100% chemical-free active ingredient
+ Broad Spectrum SPF 50/PA+++
+ Water/sweat resistant (40 minutes)
+ Dermatologist tested, hypoallergenic
+ Medium color coverage, Demi-Matte natural finish

Vegan: Yes

Active Ingredients:
Titanium Dioxide 22.5%; Zinc Oxide 22.5%.

Inactive ingredients:
Mica, Dimethicone/Vinyl-Dimethicone Cross-Polymer, Dimethiconol/Propylsilsequioxane/Silicate Cross-Polymer, Lycopodium Clavatum Extract, Sodium Hyaluronate, Imperata Cyclindrica Root Extract, Glycerin, Water, Caesalpinia Spinosa Fruit Pod Extract, Vitis Vinifera Grape Seed, Camellia Sinensis Leaf Extract, Quercus Robur (Oak) Wood Extract, Helianthus Annuus (Sunflower) Shoot Extract, Maltodextrin, Methicone, Triethoxycaprylylsilane, Laureth-4, Sodium Benzoate, Sorbate potassium, Green chromium oxide (CI 77288), Iron oxides (CI77491, CI 77492, CI 77499).

Translated with (free version)

1. OPEN: Remove brush cap, pull sleeve back, then remove and discard rubber band. Replace the cap.

2. ACTIVATE: With the cap still in place, hold the brush with the cap down and tap 3-5 times on a hard surface. Power up those taps! Then remove the cap and run your finger through the bristles to make sure the powder is flowing. Repeat the tapping as needed, until you see a small puff of powder in the air when you run your finger through the bristles.

3. APPLY: Using small circular motions, sweep directly onto dry bare skin, moisturized skin or over makeup. Apply generously to your face for at least 60 seconds in several passes. Don't forget your ears, neck and other areas! Reload powder into bristles by shaking brush with bristles down, or recap, tap and pat as needed during application. If applying directly over moisturizer, primer or liquid foundation, make sure the products have completely set before applying Sunforgettable®. Reapply at least every two hours for continued protection.

Translated with (free version)

You may also like...

Recently viewed products